Home 
News
News List
The belt conveyer belt belt slippage is the belt and the drive roller skid. Belt slippage is often encountered in the production of a failure, conveyor belt slippage may cause tape wear, serious when the conveyor belt burned and even cause a fire. Overcome conveyor belt slipping phenomenon, we must first find the slip reasons, and take effective measures to solve, because the belt drive mainly rely on operation of friction force between itself and the roller, the reason for the slip is because friction is too small to increase friction. The belt conveyer belt slippage solution is as follows:
1, solve the skidding hammer tensioning belt conveyor belt. Use hammer tensioning device of belt conveyor, in the belt conveyor belt slippage can add counterweight to solve, added to the belt does not slip so far. But should not be added too much, so that the belt conveyor belt to bear the unnecessary excessive tension and reduce its service life.
2, solve the screw tension or hydraulic belt conveyor belt slipping belt. Use a belt conveyor with screw tensioning or hydraulic tensioning, when belt slippage can adjust the tension stroke to increase the tension force. But sometimes the tensioning stroke is not enough, which makes the leather belt conveyor belt permanent deformation when the belt off a section to cure.
3, in the use of nylon or EP is required to travel a long time, when the trip is not enough or re curing or increase the tension trip to solve the belt conveyor belt slipping problem.
4, the belt tension is too small. The belt is not caused by the tension of the belt when the belt is out of the roller, and the tension is usually when starting.;
5, a tail roller bearing damage does not turn or roller bearing damage not too much; damage reason is too many ups and downs of the tail, not timely maintenance and replacement of damaged or rotation is not flexible components, the resistance increase caused by skidding.
6, transmission roller and conveying belt between the friction caused by insufficient slip, or because of the conveyor with water or wet environment; solution is to add some rosin in the roller end; but be careful not to use hand feeding, and the application of blasting equipment into, in order to avoid accidents;
7, starting speed too fast can also form a skid; this time can start slowly, such as the use of squirrel cage motor, can point to start after two times, can effectively overcome the phenomenon of slipping;
8, a conveying belt load is too large, exceed the motor power can be slippery. At the same time, slipping advantageously side is to protect the motor; or else a long time motor will be burnt; but for operation is slipping accidents.
